One should produce testing the surface of that newly entered of nakopitel 4 in the following sequence:
23) Test->.Bufer – testing the data bus  Ata- interface.
24) Merge Defects G ->.p – the transfer of the defects of those acquired is earlier (in the process of operation) in  P -.list  of accumulator.
25) Actions - > Quick Clear – for eliminating  Unc- the errors, not caused by the physical surface damage.
26) Test - > Verify forward(.reverse) -  the rough testing of surface by verification. Obtained defects during  the tests  not to hide,  but to accumulate in the list.
27) Recovery -  the concealment of the obtained defects  by united list  into  P -.list.
28) Test - > Write forward – formatting surface after the concealment of defects obtained in  verify- tests.  So into each sector of zanosits 4 its number –for the subsequent testing of the errors of the translator of accumulator.
29) Test->.Read+.Check – testing surface by reading and checking the translator of accumulator.
30) Test->.Defectoscope – testing (thinner) surface with the installation of the maximum time of the response of surface.
31) Recovery -  the concealment of the obtained defects  by united list  into  P -.list.
32) Actions - > Quick Clear – formatting surface after the concealment of defects in  P -.list.
33) Test->.Defectoscope – the output testing of surface.

It is possible to repeat any test repeatedly if necessary, but one should remember that  after any placement of defect into  P -.list  surface of accumulator this defective sector one should otformatirovat' anew.

From that stated above follow the following installations of the parameters of window  "Logical test":
5) or flag  "Try to recovery"  must be discarded, and the moment of the concealment of the list
defects it will be selected by user itself on the pushing  of knob  "Recovery"  in
the dialogue of the result  of testing.
6) or flag  "Try to recovery"  must be mounted, then in  the list  "Recovery"  it is necessary to select the moment of concealment  "After last test".  But in this case the concealment of the list of defects the test of record must directly follow!

It is possible to use the version of the concealment of defects not in  P -.list,  but in  G -.list.  Then formatting surface after the concealed defective sector is not required, and tests pove of rkhnosti can be carried out in any order. Exception will compose only the test  "Read+.Check",  which requires the required preliminary prescribing of sectors in the test  "Write forward(.reverse)".
The concealment of defective sectors in  G -.list,  in contrast to the concealment in  P -.list,  does not shift the logical surface of disk; therefore data of user and their arrangement relative to the beginning of disk  in all rest sectors  they will be preserved. By these is possible of vospol'zovat's 4 if necessary to hide certain stake - in defects during the restoration of data from the accumulator.