During the random interruption of the procedure of the concealment of defects should be carried out the actions described in the division "debugging ".

In other respects it should be noted that because of the limitations of the microprogram of accumulator the direct introduction of defects with the physical coordinates is hindered. Therefore the addition of defects from the dialogue defect - sheet to window  P  and  G of sheets is blocked. Given dialogues are left as informative, for obtaining the information about the state of sheets at the current moment.
In dialogues  P -.list  and  G -.list  it is possible to produce cleaning sheets. For this it is necessary to cause by the right knob of the mouse of the menu of sheet and to harvest point  "Clear".
During cleaning  P -.list  automatically is cleaned  G -.list.  Cleaning  G -.list  NOT vliya yet to contained  P -.list.
 
If necessary for the transfer of defects from  G sheet into  P sheet follows vospol'zovat's 4 main menu, by point  Actions - > Merge defects G ->.p.

Initsializatsionnye files
File HDD. INI
Section  [ SConner ]  determines name for the files of resources.

Key  Resource name format  assigns the size of name for the resource. Size can be the arbitrary collection of the symbols, in which can be included the following special macrosubstitutions:
? %.l – complete name of accumulator. For example, for accumulator  Seagate ST3431 Á  instead of this macro will be substituted  ST3431Á.
? %.s – short name. For the contemporary yemennykh accumulators  Seagate  it does not have sense, but as a whole –will substitute name from the end and to the right-most gap. therefore for already upominavshegos of 4 accumulators will be substituted name  ST3431Á.
? %.r – version of the micro-code, bear as soon as two first fields of complete version! For polucheni of 4 complete versions of the micro-code it is necessary to look the code of family. It is left for the compatability with other accumulators. Example:  rev_3_03.
? %.f – code of family, the complete version of the microprogram of accumulator, unambiguously it is described by 4 within the limits of model. Example:  fcode_3_03_032.
? %.n – plant address. It can be useful in the case of guarantee elevation of rata (if you will write all official regions of passing through your hands accumulators). Example:  SN7CR05BP6.