Sequence of testing the surface
For accumulators  U6  formatting logical surface is the record into the formatiruyemuyu region of any data through  Ata- interface (on the logical coordinates).
Imperatively one should conduct formatting accumulator, also, before beginning, strictly, the search for defects. The preliminary formatting of surface is necessary for the exception of interpr of etatsii as  the physical defects  of sectors with the incorrect  Comte by the rolled sum  and the sectors with the incorrect  number of sector  in his title.
For accelerating formatting  entire  surface we advise to use a point of menu  Actions - > Quick Clear.
Point  "Quick Clear"  in the utility is realized with the aid of  Ata- command  Security Erase Unit;  therefore during the random interruption of the rapid erasure of accumulator will have to remove the password established by utility from it.

The possibility of checking the surface on the logical coordinates only requires the required formatting of surface after the sequential concealment of defects in  P -.list.  Otherwise, from the now concealed into  P -.list  defect to the end of the physical track, on the coto bark the rum defect was found, for all sectors during an attempt at reading will be returned error  UNC.  This by the noncoincidence of the numbers of these sectors in their titles with the numbers, coto bark rye caused expects the translator of accumulator. Formatting will lead to the copying Nome ditch in the titles at the correct values.

Is recommended the producing of testing pove of rkhnosti of that newly entered of nakopitel 4 in the following sequence:
12)  Test->.Bufer – testing the data bus  Ata- interface.
1 3)  Actions - > Quick Clear – for eliminating  Unc- the errors, not caused by the physical surface damage.
14) Defectlist - > G it -.list - > Clear on disk – the removal of the acquired defects (in the process of operation).
15) Test - > Verify forward(.reverse) -  the rough testing of surface by verification. Obtained defects during  the tests  not to hide,  but to accumulate in the list.
16) Recovery -  concealment of the obtained defects  by united list  into  P -.list.
17) Test - > Write forward – formatting surface after the concealment of defects obtained in  verify- tests.  So into each sector will be brought in its number –for the subsequent testing of the errors of transl of yatora of accumulator.
18) Test->.Read+.Check – testing surface by reading and checking the translator of accumulator.
19) Test->.Defectoscope – testing (thinner) surface with the installation of the maximum time of the response of surface.