Therefore concealment in  G -.list  during the repair of accumulator not r yekomenduyetsya.
Correcting the passport
If necessary of changing the name accumulator, or its logical razme of the Ra, it is possible to use the procedure of izmeneni of 4 specifications accumulators. In order to perform this operation, it is necessary to select the point of menu  Service->.Special Area - > Change Passport.  In this case on the screen the following dialogue will be given out:
 
Field  LBA count  contains the volume of accumulator in  LBA.  Fields  Size  in this case will automatically show the new volume of accumulator in millions of bytes (precisely in them usually is measured volume producers), and also –in the megas-byte (precisely this value usually is shown  BIOS).  With the aid of fields  Size  you can monitor both the and other value.
To the right on top, is arranged reference book. It is filled up on the basis of section  [ LOGICAL ]  file  SConner..ini.  Its use frees you from the memorization of constants. You can introduce there standard models and it is simple to select them. Dual flick in the line of list will transfer data from it into the fields of introduction.
Pressure on knob  OK  will carry the edited parameters into the accumulator. On knob  Cancel,  you can forego the introduction of changes.

Remember that in the accumulator X with the volume of more than  8  Gbayt field  Cyl  cannot exceed value  of 163 84.  In this case the actual size of accumulator is determined by field  LBA count.  Therefore,  with the filling of the fields of accumulator with the volume of more than  8  Gbayt with the latter must be filled up field  LBA count!

When it is desired to return accumulator to the parameters, established for this disk at the plant, it is possible to use the point of menu  Service->.Special Area->.Restore Passport.
Correcting passport should be produced after the concealment of all defects on pove of rkhnosti, since during the procedure of the concealment of defects is produced the discharge Pa of rametrov of passport to avoid interference of accumulator.
Work from flesh - by memory
On accumulators  Seagate U6  are established flesh - PZU, in which is written down the starting microprogram of accumulator.
No other microprogram (for example, mask PZU in OEVM of disk) on accumulators  Seagate U6  it is provided.  In view of this, the loss of microprogram into flesh - PZU will lead disk into the completely inefficient state. In this case mik roskhemu PZU will have to unsolder from the pay and to pierce on the programmer.
The means of contained PZU, counted through ATA- interface and means, poured in PZU on the programmer, they are distinguished by the transposition of the segments of data.

From the aforesaid it follows that work from flesh - PZU of accumulators  Seagate U6  one should extremely carefully.  Do not attempt to flood into the accumulator unknown piercing and do not turn off the nourishment of accumulator during the programming by the accumulator of your fl 3w - PZU.