Therefore:
3) in the utility is provided the automatic conversion of the check sum (for those moduli, by which this it is necessary) during an attempt at their record;
4) after the record of modulus should be it considered conversely, in order to verify was accepted accumulator your changes.
Work with the moduli of the accumulator
For the access to the moduli of official region select the point of menu Service - > CP Operations. The dialogue of work with the configurative pages is in detail described in the general management on complex HRT.
One should especially accurately relate to the moduli with signature SYS1 and SYS2, since these moduli contain the most important adaptive tuning of nakopitel 4, introduced there in the plant testing. With their loss the accumulator can ispor of tit's 4 forever!
Work defect - by sheet the general information
Dialogue defect - sheet has the following points:
P+.g-.list – reflects the mixed defect - the sheet (P -.list, G -.list and Track-.list odnov belt)
P -.list – plant (sectorial) defect - sheet.
G -.list – the sheet of the acquired defects. In it are placed the defects, discovered in so on to otsesse of the operation of accumulator.
Track – track defect - sheet.
Logical – window for adding the defects in the logical coordinates. You can either introduce the defects through this dialogue or import them from the file, sfor mi rovannogo by any program of testing logical surface. Then it is necessary to cause by the right knob of the mouse of menu defect - sheet and to harvest point "Upload". Defects will fall in P -.list.
One should remember that after the addition of defects into P -.list it is necessary to produce formatting surface.
Special features defect - sheet of accumulators Seagate U6
The defect - the sheet of accumulators Seagate U6 should be carried to the special features:
5) the placement of defects in the utility is possible only by way of the indication of their logical coordinates;
6) the procedure of pomeshcheni of 4 defects in P -.list is sufficiently prolonged, since it requires the subsequent conversion of the translator of accumulator. The time of conversion depends on general stake - VA of defects in P -.list and can range from 7 seconds to 6 minutes. This is caused by the low speed by the utilized in the disk OEVM and large complexity of the algorithm of the addition of defects.
7) the addition even of one defect requires the required dual of perezag of ruzki of accumulator. Utility carries out reloadings automatically.
During the random interruption of the procedure of the concealment of defects should be carried out the actions described in the division "debugging ".
In other respects, it should be noted that because of the impossibility of obtaining by the user of information correspondence Phiz. the coordinates of defect its LBA, direct introduction of defects with the physical coordinates into the sheets is hindered. Therefore the addition of defects from the dialogue defect - sheet to window P and G of sheets is blocked. Given dialogues are left as informative, for obtaining the information about the state of sheets at the current moment.
上一篇：HRT的Seagate Drives U8, V8, U10英文说明书
下一篇：HRT的Seagate Drives Ux英文说明书 |
