Nominal sections –this of the section of the description of families. The names of the sections must coincide with those, which are assigned in the section  [ MODELS ].

In any of the nominal sections the following keys are possible:
CP TimeOut  Is determined the maximum waiting time of the readiness of accumulator during reading  CP  in milisekundakh.
CP LIST  Is determined the enumeration of the moduli of official region, which are subject to readout. The fact is that the turning to certain of the moduli, causes the "hovering" of nakopitel 4 and is necessary to exclude them from the work.
For the savings of place, can be assigned both the concrete moduli and ranges. Thus, for instance, record  by 1,2,3,4  it indicates: "to place in the list moduli with numbers  1, 2, 3  and  4",  but record  by 1-4  indicates the same. But record  by 1-4,10-20  indicates "to place in the list moduli with the numbers from  1  to  4,  and also from  10  to  20  inclusively".

The standard value of this key for  Seagate U6  is such:  CP LIST = 0-2,4-34,221
Additional possibilities of the utility
Discharge  Smart- of the variables
After the repair of accumulator frequently appears the need for throwing out  Smart- variables and  Smart- the ravines  of the repaired disk, which contain the information, accumulated in the period of the operation of disk with the malfunction. For this follows vospol'zovat's 4 by point of menu  Actions - > Clear SMART.

Removal  Ata- the password
For the removal established  Ata- password it follows to use the point of the menu
Actions - > Unlock.

Restart of the accumulator
Sometimes can arise the need for perezagruzit' accumulator. In this case, if accumulator is found in the readiness on  Ata- to interface, is possible vospol'zovat's 4 by point  Reset->.Super.  To accumulator will be fed the command of the complete reloading of mikroprog of rammy.

Work with  Vendor- by the region of the accumulator
In accumulators  Seagate U6  developers provided region for "personal P of repiski" of service engineers. This region, is more accurate, its first half, in no way not ispol'zuyets 4 in the work of accumulator, but it is accessible through  Ata- interface and makes it possible to bring in all possible records. For example, in it it is possible to note the date of the entering of accumulator in the repair, the method of repair and the date of the beginning of warranty period. With the guarantee recovery of nakopitel 4, after reading these records (from the accumulator itself!) You can either refuse in the guarantee (if elapsed warranty period), or make conclusions about expediency and procedure of further repair.
Access to  Vendor- to region  is effected by means of menu  Actions - > Vendor Data.
Part  Vendor- of region, located in its end itself, overlaps the modulus of the table of defects. Therefore to write in  Vendor- region is recommended only into its first half.