Field LBA count contains the volume of accumulator in LBA. Fields Size in this case will automatically show the new volume of accumulator in millions of bytes (precisely in them usually is measured volume producers), and also –in the megas-byte (precisely this value usually is shown BIOS). With the aid of fields Size you can monitor both the and other value.
To the right on top, is arranged reference book. It is filled up on the basis of section [ LOGICAL ] file SConner..ini. Its use frees you from zapominani of 4 constants. You can introduce there standard models and it is simple to select them. Dual flick in the line of list will transfer data from it into the fields of introduction.
Pressure on knob OK will carry the edited parameters into the accumulator. On knob Cancel, you can otkazat's 4 from the introduction of changes.
Remember that in the accumulators with the volume of more than 8 Gbayt field Cyl cannot exceed value of 16384. In this case the actual size of accumulator is determined by field LBA count. Therefore, with the filling of the fields of accumulator with the volume of more than 8 Gbayt with the latter must be filled up field LBA count!
When it is desired to return accumulator to the parameters, established for this disk at the plant, it is possible to use the point of menu Service->.Special Area->.Restore Passport.
Correcting passport should be produced after to skryti 4 all defects on pove of rkhnosti, since during the procedure of the concealment of defects is produced the discharge Pa of rametrov of passport to avoid interference of accumulator.
Work from flesh - by memory
On the majority of accumulators Seagate Ux are established OEVM with mask PZU. Only the small part of similar accumulators entered with external sequential PZU. In these PZU (mask or sequential) is written down starting mikrop of rogramma of accumulator.
Utility makes it possible through Ata- interface to read the microcircuit of sequential PZU by means of dialogue Actions->.Flash operations.
Designation of the knobs of the dialogue:
Read from HDD reads sequential PZU from the accumulator.
Write to HDD blocked is left only for the compatability of versions.
Load from file and Save to file, correspondingly, reads into the buffer and preserves from bufe of the Ra given in / from the file.
Recalc CRC Is intended for the conversion of the check sum of sequential PZU.
Dump it makes it possible for you to look over the dump of contained PZU of those locating in the buffer of utility.
Lower than the knobs is arranged window stake - VA of bytes in the buffer and the flag of correctness Comte the rolled sum.
Work with the official region
General information
The official region of accumulators Seagate Ux contains the moduli, necessary for the work of accumulator in the user regime. The part of the moduli contains the usable so on ogrammnyy code, podgruzhayemyy in OZU for the fulfillment as needed in the work. Another part contains tuning accumulator and identification information.
上一篇：HRT的Seagate Drives U6英文说明书
下一篇：HRT安装技巧经验 |
