One should remember that after the addition of defects into P -.list it is necessary to produce formatting surface.
Special features defect - sheet of accumulators Seagate Ux
The defect - the sheet of accumulators Seagate Ux should be carried to the special features:
1 2) the placement of defects in the utility is possible only by way of the indication of their logical coordinates;
13) the procedure of the placement of defects in P -.list is sufficiently prolonged, since it requires the subsequent conversion of the translator of accumulator. The time of conversion depends on general stake - VA of defects in P -.list and can range from 7 seconds to 6 minutes. This is caused by the low speed by the utilized in the disk OEVM and large complexity of the algorithm of the addition of defects.
14) the addition even of one defect requires the required dual reloading of accumulator. Utility carries out reloadings automatically.
During the random interruption of the procedure of the concealment of defects should be carried out the actions described in the division "debugging ".
In other respects, it should be noted that because of the impossibility of obtaining by the user of information correspondence Phiz. the coordinates of defect its LBA, direct introduction of defects with the physical coordinates into the sheets is hindered. Therefore the addition of defects from the dialogue defect - sheet to window P and G of sheets is blocked. Given dialogues are left as informative, for obtaining the information about the state of sheets at the current moment.
In dialogues P -.list and G -.list it is possible to produce cleaning sheets. For this it is necessary to cause by the right knob of the mouse of the menu of sheet and to harvest point "Clear".
During cleaning P -.list automatically is cleaned G -.list and Track-.list. Cleaning G -.list does not influence contained P -.list and Track-.list.
Actions->.Quick Clear – For eliminating Unc- the errors, not caused by the physical surface damage.
Initsializatsionnye files
File HDD..INI
Section [ SConner ] determines name for the files of resources.
Key Resource name format assigns the size of name for the resource. Size can be the arbitrary collection of the symbols, in which can be included the following special macrosubstitutions:
? %.l – complete name of accumulator. For example, for accumulator Seagate ST32001Â instead of this macro will be substituted ST32001Â.
? %.s – short name. For the contemporary accumulators Seagate it does not have sense, but as a whole –will substitute name from the end and to the right-most gap. therefore for already upominavshegos of 4 accumulators will be substituted name ST32001Â.
上一篇：HRT的Seagate Drives U6英文说明书
下一篇：HRT安装技巧经验 |
