|The authors warn that the use of a utility "HDD Repair Tool for Seagate U6 " is permissible ONLY with accumulators Seagate U6.
An attempt at the application of a utility on the accumulators of other models can lead to their irreversible spoiling!
BEFORE beginning the repair of accumulator, immediately after the start of utility, obyazatel'-
but it is necessary to preserve in the archive its contained flesh - PZU and disk moduli.
? flesh - PZU can be counted by means of dialogue Actions->.Flash operations;
? disk moduli can be counted by means of dialogue Service - > CP operations.
Look the detailed description of work with these dialogues in the appropriate divisions of documentation.
With the pushing of the right knob of "mouse", the program issues on the screen the main menu, the hierarchy of points of which is given below:
The designation of the points of menu will be described below.
Testing the accumulator
Upon the entering of nakopitel 4 in the repair should be compulsorily thoroughly looked around its printed-circuit board to the object of the visible malfunctions of electronic components, and so to the object of the possible substitution of pay, since the printed-circuit boards of accumulators Seagate U6 on to their of forms - to factor they coincide with the printed-circuit boards of accumulators Seagate U4, Seagate U8, Seagate V8, Seagate U10 and Seagate U5. During the detection of substitution should be replaced the pay.
So should be verified by tester resistance between the common wire and the power buses of +.shchV and +.y2V:
? on the power bus of +.y2V resistance must be about 71 kљ;
? on the power bus of +.shchV resistance must be about 1.4 kљ.
We further connect accumulator to pay HRT and start utility. Accumulator must leave into the readiness - in the field of the "window of light-emitting diodes" must ostat's 4 "burn" only flags DRDY and DSC.
The work of utility with the accumulators, which do not emerge into the readiness on Ata- to interface, is impossible! This is caused by the limitations of the microprogram of the very of nakopitel 4.
After the start of utility will appear the window, in which will be represented kha rakteristiki of accumulator.
Focus attention, that the complete name of the microprogram of accumulator, printed out in field Family code, contains 5 numbers, grouped into 3 fields. However, gluing on the housing of accumulator contains only the first two fields of the version of microprogram in the line "Firmware".
Special features of testing accumulators Seagate U6
Unfortunately, all accumulators Seagate U for a series do not permit implementation of access through Ata- interface to the surface of disk directly in the physical coordinates. Firm herself Seagate achieves testing accumulators with the aid of the special version of microprogram, loaded before the plant testing into flesh - PZU of nakopitel 4. After the end of testing microprogram into flesh - PZU they substitute by the user version, which does not have the commands of access to the physical surface.
上一篇：HRT的Seagate Drives U8, V8, U10英文说明书
下一篇：HRT的Seagate Drives Ux英文说明书